 |
 |
||
 |
|||
 |
 |
||
 |
 |
||
 |
|||
 |
|||
 |
|||
 |
|||
 |
|||
 |
|||
 |
|||
 |
|||
 |
 |
|
|
|
 |
||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
Product Description EconoKORE is a highly flexible 2-ply product designed for use in numerous kinds of radius projects. It consists of a core of kerfed MDF with a High Density or Poplar Plywood overlay. Product Characteristics Normal application of econoKORE involves using standard fabricating techniques that are associated with 3/8" bending ply and other post-laminated bending materials. A flexible product that can be easily bent and attached to a ribbed frame by the use of nails, staples or glue. Attachment Methods The kerfed material can be formed and held in position with the use of most adhesives and staples when necessary. The use of horizontal ribs for attachment is preferred as this will provide the best support to allow the material to achieve the smoothest radius possible. Laminating Methods Face applications can be achieved with any contact cement recommended for use with decorative laminates. When using contact adhesive, light to moderate pressure is adequate. Firm hand pressure or moderate pressure with a J-roller works well. Use of PVA glue is also acceptable for attaching face material provided it can be used during or after forming the econoKORE. When using a PVA glue, make sure the glue is transferred to both materials and that adequate uniform pressure can be applied for the required amount of time. Horizontal or vertical laminate grades are recommended. As with any product, it is best to do a test on a small sample to determine how the materials will work together. Use of PVA glues is also acceptable for attaching face material provided it can be used during or after forming the econoKORE. When using a PVA glue, make sure the glue is transferred to both materials and that adequate uniform pressure can be applied for the required amount of time. Horizontal or vertical laminate grades are recommended. As with any product, it is best to do a test on a small sample to determine how the materials will work together. Bending Capabilities The recommended bending radius obtainable is approximately 6-8 inches. While a smaller radius may be obtainable, it is best to do a test before proceeding. Temperature Conditioning EconoKORE should be acclimated the same as the face materials that will be applied to it. If available, use the guidelines recommended by the face material manufacturer. Handling Care should be taken in handling all materials. The size and weight may require two people. Be careful to pick up the material in such a manner as not to pinch fingers in the ribs. Try to not over flex the material or bend it past the recommended radius when handling. Storage All products should be stored flat with the face material side facing up. Keep in dry area, away from direct contact with the floor to allow for air circulation. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||
econKORE Classifications & Dimensions
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||